Usually case, residents in the renovation of the new house, walk the line is essential for a job; wire and cable manufacturers said, now indoor circuit wiring, switch socket arrangement, chandeliers, ceiling fan installation, for the sake of convenience, the pursuit of beauty, material saving, to not in accordance with the rules of the device are, thus planting under the hidden dangers of accidents. So wire and cable manufacturers need to remind everyone: in the decoration wiring, the staff should do the following:

1, in your house into the line, be sure to install with the current standards in line with the current leakage protection device. Because of the leakage switch, once the leakage phenomenon occurs at home, it will cause the occurrence of dangerous accidents;

2, in the indoor wiring, lighting and socket circuits separation of wiring and circuit socket should be using a section of not less than 2.5 square millimeter of single strands of insulated copper wire, lighting circuits should be using a section of not less than 1.5 square mm single strands of insulated copper wires. Large capacity electrical equipment should be independent of the equipment capacity configuration of the corresponding large capacity sockets and loops.

3, specific wiring, the plastic sheath wire or other insulating conductor should wear protective tubes and shall not be directly buried in the cement or lime stucco house.

4, socket installation height from the ground height 1.3 meters, the lowest shall be not less than 0.15 m, socket wiring, the single-phase two hole socket, the socket in the face of the left hole connected with the zero line, the right hole connected phase (fire) line; single-phase three hole socket, socket in the face of the left hole is connected with a zero line, the right hole connected phase (fire) line and hole connected line protection. Do remember that the upper hole is strictly forbidden to connect to the left hole.